Intermec PD41

Appendix B — Default Settings
112 PD41 and PD42 Commercial Printer User’s Manual
Fingerprint Default Configuration
Media Parameters
Parameter Default Value
Media type Gap
Paper type DT (Direct Thermal)
LBL length dots 1200 dots
Testfeed mode Fast
Sensitivity 420
Darkness 0
LBL rest point 0
Form adj dots X +0
Form adj dots Y +0
Configuration Parameters
Parameter Default Value
Emulation mode None
Print speed 5 in/sec
Cutter Not installed
Ser-Com “uart1:” Parameters
Parameter Default Value
Baud rate 9600
Character length 8
Parity None
Stop bits 1
Flow control
RTS/CTS
ENQ/ACK
XON/XOFF; data to host
XON/XOFF; data from host
Disable
Disable
Disable
Disable
New line CR/LF
Receive buffer 1024 bytes