Intermec PD41

Chapter 1 — Using the Printer
PD41 and PD42 Commercial Printer User’s Manual 19
6 Load media in the printer For help, see “Loading Media for Tear-
Off Printing” on page 11 or “Loading Media for Peel-Off
(Self-Strip) Printing” on page 12.
7 Press the Print button to advance the media.
Printing a Test Label
To verify that the printer is fully functional and to obtain the current
configuration, you can print the test labels. The test labels contain
hardware and software configuration information.
To print a set of test labels
1 Turn off the printer.
2 Load media and ribbon (if necessary). For help see, “Loading
Media” on page 11 and “Loading Thermal Transfer Ribbon”
on page 16. Make sure the printhead is down.
3 Press and hold the Print button.
4 Continue to keep the Print button pressed down and turn on the
Power switch. After approximately ten seconds, the printer screen
lights up, runs a media setup routine, enters Testmode, and three
of the LEDs start to flash one at a time (green, red, and then blue).
5 Continue to press the Print button until the printer starts cycling
through the selectable media types: gap, mark and continuous.
6 Select your media type by releasing the Print button when your
type of media appears on the screen.
SELECT MEDIA
GAP
SELECT MEDIA
MARK
SELECT MEDIA
CONTINUOUS