Intermec PD41

Chapter 3 — Configuring the Printer
52 PD41 and PD42 Commercial Printer User’s Manual
Configuring the Network Type
Use the Network Type page to choose whether you are using an
Ethernet or wireless 802.11 network.
To configure the network type
1 Click Network Admin > Network Type.
2 Select either Ethernet or Wireless 802.11.
3 Click Submit new settings.
4 Reboot the printer for the changes to take effect.
Configuring Avalanche Settings
Use the Avalanche page to view and change Wavelink Avalanche
settings.
To configure Avalanche settings
1 Click Network Admin > Avalanche.
2 View or update your settings.
Name Resolution DNS Server: The IP address of the name server.
DNSv6 Server: The IP address of the name
server for IPv6.
WINS Server (Primary and Secondary): The IP
addresses of the primary and secondary WINS
servers. If you chose DHCP or BOOTP for the
configuration method, you may see the currently
assigned WINS IP addresses depending on the
configuration of your DHCP server.
Printer Service NET1 TCP Port Number: The port number for
raw TCP. The default is 9100.
NET1 Queuing: Determines whether queuing
for the TCP port is turned on, off, or enabled for
multiple network connections (Multi).
Understanding the TCP/IP Settings (continued)
Setting Description
Note: Once you change the network type to Wireless 802.11, you
cannot communicate with the printer using Ethernet. You need to
change the command through the Setup menu or send a command
through a serial connection.