Intermec PD41

Chapter 2 — Connecting the Printer
26 PD41 and PD42 Commercial Printer User’s Manual
To configure the IP settings serially using Fingerprint
1 Connect the printer to your PC using a serial cable. For help, see
“Connecting the Printer to a PC Through the Serial Port” on
page 22.
2 Send the following commands to permanently assign the IP
address, subnet mask, default router, and name server:
setup "network,IP selection,manual"
setup "network,IP address,xxx.xxx.xxx.xxx"
setup "network,netmask,xxx.xxx.xxx.xxx"
setup "network,default router,xxx.xxx.xxx.xxx"
setup "network,nameserver,xxx.xxx.xxx.xxx"
where xxx is a number from 0 to 255.
3 Disconnect the printer from the PC.
4 On your PC, enter the IP address of the printer in the address field
of your web browser (for example http://10.200.27.94) and press
Enter.
The home page of the printer appears.
To configure the IP settings serially using IPL
1 Connect the printer to your PC using a serial cable. For help, see
“Connecting the Printer to a PC Through the Serial Port” on
page 22.
2 Send the following commands to permanently assign the IP
address, subnet mask, default router, and name server:
<SI>nn[,m1[,m2]]
where:
n is the IP address of the printer in the format n.n.n.n, where n is a
number from 0 to 255.
,m1 is the subnet mask address in the format n.n.n.n, where n is a
number from 0 to 255.
,m2 is the router address in the format n.n.n.n, where n is a number
from 0 to 255.
Note: You must specify at least two of the three parameters for the
command to take effect.