Intermec PD41

Appendix A — Specifications
PD41 and PD42 Commercial Printer User’s Manual 101
Self-Adhesive Labels
Liner (b)
The backing paper must not extend more than a total of 1.6 mm
(0.06 in) outside the labels and should protrude equally on both sides.
* The print length is limited by memory constraints
Media Width Including Liner (a)
Measurement Value
Maximum 118 mm (4.65 in)
Minimum 25.0 mm (1.00 in)
Label Width Excluding Liner (c)
Measurement Value
Maximum 116.4 mm (4.58 in)
Minimum 23.8 mm (0.94 in)
Label Length (d)
Measurement Fingerprint IPL ESim
8 dots/mm (203 dpi)
Maximum 1270 mm (50 in)* 600 mm (23 in) 600 mm (23 in)
Minimum 6.0 mm (0.2 in) 6.0 mm (0.2 in) 6.0 mm (0.2 in)
11.81 dots/mm (300 dpi)
Maximum 558.8 mm (22 in)* 406.4 mm (16 in) 406.4 mm (16 in)
Minimum 6.0 mm (0.2 in) 6.0 mm (0.2 in) 6.0 mm (0.2 in)
Label Gap (e)
Measurement Value
Maximum 26.0 mm (1.02 in)
Recommended 3.0 mm (0.12 in)
Minimum 1.2 mm (0.05 in)