Intermec PD41

Appendix A — Specifications
PD41 and PD42 Commercial Printer User’s Manual 105
Tickets With Black Mark (Mark Stock)
* The print length is limited by memory constraints
LSS Detection Position (c)
Variable from 0 to 57 mm (0 to 2.24 in).
Black Mark Width (d)
The detectable width of the black mark should be at least 5.0 mm
(0.2 in) on either side of the LSS detection point.
Black Mark Y-Position (f)
Intermec recommends that you place the black mark as close to the
front edge of the ticket as possible and use a negative Stop Adjust
value to control the media feed, so the tickets can be properly torn off.
Media Width (a)
Measurement Value
Maximum 118 mm (4.65 in)
Minimum 25.0 mm (1.00 in)
Copy Length (b)
Measurement Fingerprint IPL ESim
8 dots/mm (203 dpi)
Maximum 1270 mm (50 in)* 600 mm (23 in) 600 mm (23 in)
Minimum 6.0 mm (0.2 in) 6.0 mm (0.2 in) 6.0 mm (0.2 in)
11.81 dots/mm (300 dpi)
Maximum 558.8 mm (22 in)* 406.4 mm (16 in) 406.4 mm (16 in)
Minimum 6.0 mm (0.2 in) 6.0 mm (0.2 in) 6.0 mm (0.2 in)
Black Mark Length (e)
Measurement Value
Maximum 25.0 mm (0.98 in)
Common 5.0 mm (0.2 in)
Minimum 3.0 mm (0.12 in)