Chapter 4 — Troubleshooting and Maintaining the Printer
84 PD41 and PD42 Commercial Printer User’s Manual
4 Carefully turn both screws, at the front of the printhead, clockwise
a quarter of a turn at a time.
5 Close the printhead and using the slotted screwdriver to turn the
two screws at the top of the printhead bracket clockwise a single
turn.
6 If you are using thermal transfer ribbon, load it.
7 Test and readjust if necessary.
Note: Be sure you make identical adjustments on both screws. If you
are unsure, tighten both screws completely by turning them
counterclockwise as far as they will go, and then start over.
To Next Page
Loading...
