Chapter 1 — Using the PW50 Workboard Printer
PW50 Workboard Printer User Guide 7
Installing the Battery
Make sure you fully charge the battery before you use your PW50. You
can charge the battery before or after you install it in the PW50.
To install the battery
1 Lay the PW50 upside down on a flat surface.
2 Insert the battery with the tab facing away from the front control
panel.
Use only Intermec battery pack Model AB13. Use of incorrect
battery may present a risk of fire or explosion. Promptly dispose
of used battery pack according to the instructions.
The Model AB13 battery may ignite, create a chemical burn
hazard, explode, or release toxic materials if mistreated. Do not
incinerate, disassemble, or heat above 100 °C (212 °F). Do not
short circuit; may cause burns. Keep away from children.
To Next Page
Loading...
