Chapter 3 — Troubleshooting and Maintaining the PW50
32 PW50 Workboard Printer User Guide
To cold boot the PW50
1 Disconnect the PW50 from power if externally powered.
2 Remove the battery from the PW50 for at least one second.
3 Insert the battery back into the PW50.
4 Reconnect external power if your PW50 is externally powered.
Cleaning the PW50
To properly maintain your PW50, you should clean it at the
recommended intervals.
PW50 Workboard Printer: Identifying the parts of the PW50 to clean
regularly.
To avoid possible personal injury or damage to the printer, never
insert any pointed or sharp objects into the printer.
Use only the cleaning tools specified in this section. Intermec is
not responsible for damage caused by any other cleaning
materials used on this printer.
Platen roller
Paper sensor
Tear bar
Printhead
To Next Page
Loading...
