Intermec PW50

Chapter 2 — Configuring the PW50
PW50 Workboard Printer User Guide 23
3 Print a testprint to verify that your firmware was upgraded
correctly. For help, see “Printing a Testprint” on page 12.
4 Cold boot the PW50. For help, see “Cold Booting the PW50” on
page 31.
Understanding the Printer Modes
The PW50 has five modes to help you effectively interact with the
printer: Ready, Pause, Error, Test, and Upgrade. Use the following
sections to understand the different printer modes.
Understanding Ready Mode
The printer is in Ready mode when the printer is on and ready to
print.
Understanding Pause Mode
Use Pause mode to momentarily stop printing or to cancel a current
print job. Use the Feed button to both pause and resume printing.
To enter Pause mode
• Press the Feed button while the printer is printing.
To resume printing
• Press the Feed button while the printer is paused.
To cancel a print job
1 Press the Feed button to pause printing.
2 Press and hold the Feed button to cancel the print job.
Understanding Error Mode
The printer enters Error mode when it detects an error condition such
as a low battery or a paper fault. When the printer is in Error mode,
the status LED blinks red.