Chapter 1 — Using the PW50 Workboard Printer
12 PW50 Workboard Printer User Guide
6 Press down on the cover until it latches. The printer emits the
hardware sound to tell you that the media door closed correctly.
7 Press the Feed button to advance the media.
Printing a Testprint
Before you can use a new printer, or a printer that you reset to factory
default settings, you must perform a testfeed. After you load media in
the printer, you are ready to print a testprint.
If you cannot get the testprint information to print, see Chapter 3,
“Troubleshooting and Maintaining the PW50.”
To print a testprint
1 Make sure the PW50 is in Standby mode and is loaded with media.
2 Press and hold the Standby and Feed buttons until the PW50
beeps.
To Next Page
Loading...
