Appendix B — Default Settings
SR30 Handheld Scanner User’s Guide 43
Tolerance No tolerance
Beeps/green indicator LED
Volume High
Note (tone frequency) High (2090 Hz)
Power-up beeps/Power-up LED On
Good read beeps
Number 1
Duration 80 ms
Timing Before transmission
Good read LED duration 80 ms
Error beep On
Setup beep On
Bad read message Not active
Default=“NOREAD”
Operating Setting Commands (continued)
Command Default Value
Note: The next table applies to area imagers only.
Imager Setting Commands
Command Default Value
Pre-defined imager settings
1D codes only N/A
Standard 1D and 2D codes N/A
1D and 2D codes, bright environment N/A
1D and 2D codes with reflective surface N/A
General
Aimer flashing Aimer flashing
(optimized for
decode)
Decode mode 2D imager
To Next Page
Loading...
