Chapter 1 — Introducing the SR61B Cordless Scanner
SR61B Cordless Scanner User’s Guide 5
Understanding the SR61B Behavior
The SR61B uses lights, beeps and vibrations to indicate if a bar code
has been successfully decoded. The lights and beeps described in this
section are new and do not correspond to the legacy SR61B models
(SR61BV, SR61BA, SR61BL or SR61BE).
Intermec-Ready-to-Work Indicator
The Intermec-Ready-to-Work indicator ™ (blue LED) gives
information about the Bluetooth connection. When a connection has
been established the light is always on (blue) unless the scanner is
docked in a charge base. In this case the blue light turns off even
though the Bluetooth connection is still active.
When using your scanner to scan bar codes (blue light on) your
scanner will also flash status information using green or red lights.
See the Status Light information in the next section.
Note: If you prefer to use the legacy beep and LED mode you can
activate the legacy mode using EasySet. For information on using
EasySet see “Configuring Your Scanner with EasySet” on page 31.
Blue Intermec Ready-to-Work Indicator
Light State What it Means
Off A Bluetooth connection has not been established.
OR
Scanner is docked in a charge base.
Blinking, slow The scanner is trying to establish a Bluetooth
connection with a Bluetooth device.
Blinking, fast The scanner is awaiting user acknowledgement in a
pairing procedure.
On A Bluetooth connection to the base station or host
computer is established. The SR61B is ready to scan
bar codes and send data.
To Next Page
Loading...
Need help?
General
