Chapter 2 — Connecting the SR61B
26 SR61B Cordless Scanner User’s Guide
Connecting from your Scanner as an SPP Bluetooth
Device
This section describes how to perform a scanner-initiated connection,
for example prior to collecting data.
To connect from the scanner
1 Once your scanner is paired, turn it on by pulling the trigger. Make
sure it is set as an SPP Bluetooth device.
2 Start EasySet version 5.6.5.3 or later. Make sure that SR61B is
selected as your product.
3 Select the Interface > Bluetooth > Connect/disconnect folder.
4 Double-click on the Compose BT address command. A
Bluetooth - Connect/disconnect - Compose BT address
window opens.
5 Compose your host Bluetooth Device Address (BDA) and click
OK. The Bluetooth association bar code is created.
6 Print and read the Bluetooth association bar code. The blue
Intermec Ready-to-Work starts blinking.
7 Open the incoming port that you noted at the end of the pairing
procedure, for example from a terminal emulation program.
When the scanner connects to your host PC, it emits a series of
beeps from low to high, and the blue Intermec Ready-to-Work
indicator turns solid blue.
8 To disconnect, close the incoming port.
When the scanner disconnects from your host PC, it emits a series
of beeps from high to low, and the blue Intermec Ready-to-Work
indicator turns off. The LED starts blinking.
To Next Page
Loading...
Need help?
General
