Chapter 2 — Connecting the SR61B
20 SR61B Cordless Scanner User’s Guide
4 Repeat Steps 1 to 3 to connect up to seven scanners to the
Intermec computer.
Connecting the SR61B to an Intermec SD61 Base
Station
You can connect up to seven Intermec Bluetooth scanners to the
SD61 Base Station.
To connect up to 7 scanners
1 Connect the SD61 base station to a host device using the correct
cable for your interface (see the SD61 Base Station User’s Guide
available on our website at www.intermec.com).
2 With an Intermec Bluetooth scanner, scan the association bar code
on the top of the SD61 Base Station. If you do not have a
Bluetooth association bar code label for your base station, use
EasySet to create a Bluetooth connect bar code. For help, see the
EasySet software.
The scanner beeps twice, the green status light flashes twice and
the blue Intermec Ready-to-Work indicator starts blinking. When
the scanner connects to the base station it emits a series of beeps
from low to high. The blue Intermec Ready-to-Work indicator
turns on and stays on for both the scanner and base station.
3 To add more scanners, repeat steps 1 and 2.
Note: You can also use the Intermec Bluetooth Scanner Wizard on the
Intermec computer. For help, see the documentation for your
Intermec computer.
To Next Page
Loading...
Need help?
General
