Chapter 2 — Connecting the SR61B
SR61B Cordless Scanner User’s Guide 21
Connecting the SR61B to Other Bluetooth
Devices
The cordless SR61B scanner can communicate with a host device
through the Bluetooth communications Human Interface Device
Profile (HID) and Serial Port Profile (SPP).
HID Bluetooth Device Connection
With the HID profile, your SR61B is recognized as a keyboard.
Connection information is stored, meaning that if the scanner loses
connection (out of range, low battery, etc.), it will try to reconnect as
soon as possible (back into range, charged battery, etc.). Moreover, no
specific software is needed in HID profile as opposed to SPP profile to
collect data.
Before trying to pair and connect your scanner, make sure:
• it is not already trying to establish a Bluetooth connection. If so,
the blue Intermec Ready-to-Work indicator blinks; read the
Bluetooth device disconnect bar code.
Bluetooth Device Disconnect
• it is not already paired with your Bluetooth device. If so, remove it
from your host’s Bluetooth devices list.
• your host is set to allow Bluetooth device connections.
Pairing and Connecting as an HID Bluetooth Device
This section describes how to pair and connect your scanner from
your host PC.
To pair and connect as an HID Bluetooth device
1 Turn on your scanner by pulling the trigger.
2 Scan the Bluetooth device profile - HID configuration bar code
Bluetooth Device Profile - HID
To Next Page
Loading...
Need help?
General
