Invacare G40 - Handbrake

24
8.5 Handbrake
Brake caliper
Brake disc,
disassembled
14
15, 16
12
5
11
8
6
9
13
7
10
Handbrake, diagram of bowden wires
17
Disassembly brake lever
• Release wing screw (1) and take of brake lever (2).
Disassembly brake caliper
• Disassemble front wheel. See chapter 8.2.
• Remove screws (9) with discs and nut and take off brake caliper (5).
• Release cable clamp screw with nut and disc, pull out bowden wire (6) and remove brake caliper completely.
Should the occasion arise you first must pinch off the caps of bowden wire.
• Release screws (13) with discs and nuts and disassemble the halfs of brake caliper.
• Release cross slotted screws and remove brake shoes (10).
Assembly
• Assembly is carried out in reverse order.
• Brake shoes defective?
• Brake disc defective?
• Brake does not apply?
• Brake lever defective?
> Replace brake shoes.
> Replace brake discs.
> Adjust brake.
> Replace brake lever.
Check Action
NOTE:
• Adjust brake so, that the bowden wire has a
play of 15mm. Brake completely released or
completely applied.
19
1
3
2
4
5
6
7
8
9
10
11
12
20
21
18
22
23
1 Wing screw Mx10
2 Brake lever
3 Brake straps, riveted compl.
4 Bowden wire holder
5 Brake caliper
6 Bowden wire
7 Cable clamp screw
8 Bowden wire sleeve
9 Hexagon head screw M6x25
10 Brake shoes
11 Fixing screw
12 Mounting
13 Hexagon head screw M6x35
14 Brake disc
15 Roundmagnet 625-6.0
16 Cable socket
17 Speedometer sensor
18 Wheel nut M12x1,5
19 Hub
20 Sockets
21 Starlock caps 8,0
22 Nut M8
23 Cap SKS 8
24 Disc 8,4
25 Brake lever button
24
25
Chassis