Invacare TDX 4 - Section 16-Ventilator Tray

SECTION 16—VENTILATOR TRAY
Part No 1114809 129 TDX™ Wheelchairs
SECTION 16—VENTILATOR TRAY
 WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.
Using the Optional Ventilator Tray
 WARNING
Maximum weight capacity for the vent tray is 40 lbs ± 20%. DO NOT exceed weight
capacity for vent tray - otherwise, injury or damage may occur.
CAUTION
This ventilator tray was designed to hold a ventilator that is approximately 13
inches long, 14½ inches wide, and 14 inches high. Use of ventilators larger than the
above specifications may result in damage to the ventilator or stability issues.
ALWAYS disconnect the ventilator battery harness from the ventilator battery
harness extension before connecting the ventilator battery harness to the
ventilator. Otherwise damage to the product may occur.
Wheelchairs with Recline System Only - Wheelchairs with Ventilator Trays - Any
ventilator installation MUST provide adequate clearances to allow unobstructed
mechanical operation of the seating system. In addition, some ventilators may have
additional clearance requirements. ALWAYS refer to the ventilator’s instructions
prior to installation for any additional requirements.
NOTE: For this procedure, refer to FIGURE 16.1 on page 130.
NOTE: This procedure applies to Formula TRE and 2G Tarsys Seating Systems only.
1. Position straps to the outside of the ventilator tray.
2. Position the ventilator (not shown) on the ventilator tray.
3. Disconnect the ventilator battery harness connector from the ventilator battery
harness extension (Detail “B”).
4. Connect the ventilator battery harness to the ventilator. Refer to the ventilator
manufacturer’s installation instruction.
5. Secure strap around the ventilator and clip together.