SECTION 6—FRONT RIGGINGS
TDX™ Wheelchairs 84 Part No 1114809
2. Push legrest release handle and swing legrest to the outside of the wheelchair.
3. Lift up on powered legrest and remove from wheelchair.
4. Repeat STEPS 1-3 for opposite power legrest.
FIGURE 6.23 Installing/Removing the Power Elevating Legrests
Using Mechanical Elevating/Genius Legrests
CAUTION
DO NOT operate the recline function of the seating system if one or both of the
mechanical elevating legrest push rods are bent. Damage to the seating system can
occur.
NOTE: For this procedure, refer to FIGURE 6.24.
Mechanical elevating legrests are linked to the recline function of the seating system.
Operating the recline function automatically operates elevating legrests.
FIGURE 6.24 Using Mechanical Elevating/Genius Legrests
Calf Pad
Footplate
Legrest Release
Handle
Mounting Hole
DETAIL “A”
DETAIL “B”
Jumper
Cable
Power
Legrest
Connector
Mounting Pin
Mechanical
Elevating
Legrest
Push Rod
Pin
To Next Page