SECTION 8—SEAT
Part No 1114809 97 TDX™ Wheelchairs
Tilting the Seat Assembly Forward
1. Using one hand, firmly grasp the front edge of the seat assembly and lift until seat
assembly is no longer supported by the prop rod.
2. Disengage the prop rod from the seat bracket and secure into clip.
3. Using both hands, slowly tilt the seat assembly FORWARD into the DOWN/CLOSED
position.
WARNING
Ensure the two screws are fully engaged and the Formula PTO Plus frame is
securely locked in place before use - otherwise injury or damage may result.
4. Insert the two screws through both the Formula PTO Plus frame and the two seat
brackets.
FIGURE 8.3 Tilting the Seat Assembly
Formula PTO Plus Frame
Screw
Prop Rod
Clip
Seat Bracket
Screw
Washer
Mounting Hole
To Next Page