SECTION 6—FRONT RIGGINGS
TDX™ Wheelchairs 86 Part No 1114809
Adjusting Mechanical Elevating Legrests
Calfpads
NOTE: For this procedure, refer to FIGURE 6.26.
1. Turn the calfpad toward the outside of the wheelchair.
2. Slide calfpad up or down until desired position is obtained.
3. Turn the calfpad toward the inside of the wheelchair.
FIGURE 6.26 Adjusting Mechanical Elevating Legrests - Calfpads
Footplate Height
NOTE: For this procedure, refer to FIGURE 6.27.
NOTE: The following procedure should be performed with the user in the wheelchair.
1. Loosen, but DO NOT remove, the bolt and locknut that secure the lower legrest
assembly to the upper legrest assembly.
2. Move the lower legrest assembly to the desired position for the user.
3. While holding the lower legrest in position, tighten the bolt and locknut securely.
4. Repeat STEPS 1-4 for opposite legrest if necessary.
FIGURE 6.27 Adjusting Mechanical Elevating Legrests - Footplate Height
Secure CalfpadAdjust CalfpadAdjust Calfpad
Lower Legrest
Assembly
Upper Legrest
Assembly
Bolt/Nut
To Next Page