SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING
TDX™ Wheelchairs 48 Part No 1114809
❑ Make sure all systems, except Elevate Only, have the retaining pin in place at the back
of each seat rail (Formula TRE Only).
❑ Make sure elevate systems drive with reduced speed when seat is in elevated position
(Formula TRE Only).
❑ Check that spreader bar mounting fasteners are tight (2G Tarsys and Formula TRE
Only).
❑ Check that back cane mounting fasteners and back mounting fasteners are tight (2G
Tarsys and Formula TRE Only).
Inspect/Adjust weekly
❑ Make sure all electrical connections are secure.
❑ Check that cables are routed and secured properly to ensure that cables do NOT
become entangled and damaged during normal operation of seating system.
Inspect/Adjust Monthly
❑ Make sure drive lock-out operates properly.
❑ Make sure tilt operates smoothly and properly.
❑ Make sure recline operates smoothly and properly (2G Tarsys and Formula TRE
Only).
❑ Make sure elevate operates smoothly and properly (Formula TRE Only).
❑ Make sure elevate systems drive with reduced speed when seat is in elevated position
(Formula TRE Only).
❑ Check that spreader bar mounting fasteners are tight (2G Tarsys and Formula TRE
Only).
❑ Check that back cane mounting fasteners and back mounting fasteners are tight (2G
Tarsys and Formula TRE Only).
Inspect/Adjust Periodically
❑ Check limit switch position for recline (Formula TRE Only).
❑ Make sure seating systems with the recline function have the retaining pin in place at
the top of each back cane (Formula TRE Only).
❑ Make sure all systems, except Elevate Only, have the retaining pin in place at the back
of each seat rail (Formula TRE Only).
❑ Check that spreader bar mounting fasteners are tight (2G Tarsys and Formula TRE
Only).
❑ Check that back cane mounting fasteners and back mounting fasteners are tight (2G
Tarsys and Formula TRE Only).
To Next Page