| top of page |
Network
| top of page |
Shutdown
System reset Select this option to
reset all configuration
options on the
ScreenPlay TV Link DX
to factory defaults.
Update device Select this option to
tell the ScreenPlay TV
Link DX to search the
network for a firmware
update file.
About Displays the firmware
version and product
serial number
Network setup Displays details on current network configuration, including
connection type (wired or wireless), IP address, Netmask (subnet
mask), Gateway, DNS server, and MAC address.
Select the Configure button at the bottom of the Network setup
screen to change the network configuration using either Auto
network detection or Static IP address.
Device name This is the name that will appear for the ScreenPlay TV Link DX
on the network. The default device name is "Iomega_HD". Use
the virtual keyboard or the remote control if you want to change
the name.
Media server This option applies only to the ScreenPlay DX with internal
storage. The media server option is off by default.
Shared folder When this option is on (default setting), an external USB device
connected to the ScreenPlay TV Link DX will appear as a shared
volume on the network. Select "Off" if you do not want to the
ScreenPlay TV Link DX to appear as a network share.
Workgroup name The default workgroup name is "WORKGROUP". You can change
the workgroup name using the virtual keyboard or the remote
control.
Auto login This option is off by default. When this option is set to "On", the
ScreenPlay TV Link DX will automatically login to the network at
start up. This option will allow you to set up a network password
as needed.
Clear account
information
This option deletes a previously set network password and clears
network account information.
Shutdown Completely powers down the ScreenPlay TV Link DX. You can use
To Next Page
Loading...
