TIGER Instrument User Manual V3.10
Unrivalled Gas Detection. Page 14 of 72 ionscience.com
3. Getting Started
Fitting the Inlet Probe
Ensure that the inlet probe supplied is fitted to your TIGER
Switching your TIGER On
Press the Enter / On / Off key once to turn TIGER On.
The lights will flash white, red, then amber, and a “beep” will sound. You should also be able to hear
the pump start operating.
The display will initially display the ION Science logo. It will then display a screen showing the ID of
the instrument, as entered in the Instrument ID in TigerPC, and the firmware version installed on it.
The display will then show the instrument checking that the Lamp is working (the symbol is
displayed).
Next, if the instrument is set to Zero when switched on, the screen will display the symbol.
The main running screen is then displayed:
Your instrument is now ready to use.
Switching your TIGER Off
Press and hold the Enter / On / Off key for 3 seconds to turn TIGER Off. A 3-second countdown will
be displayed on the screen. While this is happening, a continuous beep will sound, and the lights will
flash red.
Once the instrument is switched off, wait a few seconds before switching on again.
To Next Page
Loading...