IP Gear SmartCell 111L - 4.3 Immediate Dialing

IP Gear SmartCell 111L User Guide
4.2.2 Feature Programming
Enter programming mode by dialing **1343**# [hear a confirmation tone].
Enter ‘change Rx/Tx gain’ mode by dialing *5580*# [hear a confirmation tone].
Dial to a cellular phone (must have at least 3 digits), add # at the end [hear a
confirmation tone] and wait until the call is answered.
Dial *70*# [hear a confirmation tone] for Tx gain or *71*# [hear a confirmation
tone] for Rx gain.
Change the gain by using the following keys on the DTMF key pad:
Key 2# [hear a confirmation tone] - Increase gain
Key 8# [hear a confirmation tone] - Decrease gain
Note: in some units, the 2 and 8 keys were interchanged (due to a software bug
that will be corrected in the next release).
Key 6# [hear a confirmation tone] - Go back to default
Key 4# [hear a confirmation tone] - Go back to the gain before you started
Key 5# [hear a confirmation tone] - Save changes
You should hear a confirmation tone after each command. When you reach the
end of the gain scale, you will get the rejection tone (2 beeps) instead of
confirmation tone.
Make sure to push the 5 key to save the changes after you are satisfied with the
level.
4.3 Immediate Dialing
4.3.1 Feature description
The 111L will collect the digits and will start the cellular call when one of the
following events will occur:
• 3 – 9 seconds (user definable, default = 3 seconds. See par. 4.4) passed after a
digit. The 111L assumes this is the last digit. Slow or indeterminate users,
who wait more than the chosen time will encounter error situations, as the unit
will initiate a cellular call without all the required digits (except after the last
digit).
• The # key was used to indicate the end of the dialed number. The unit will not
send the # to the cellular network.
• When enough digits have been dialed and the Immediate Dialing feature is
activated.
Page 13