IP Gear SmartCell 111L - 4.8 Call Duration Limit

IP Gear SmartCell 111L User Guide
4.7 Toll Restriction
4.7.1 Feature description
When the Toll Restriction feature is enabled, the Smartcell 111L allows only
calls to numbers that starting with the prefixes that were programmed (white
list). Attempts to call numbers starting with other prefixes will fail and the caller
will hear an error tone. Numbers of 4 digits or less, including those starting with
*, are never blocked (to allow calls to emergency and other special services). The
list of allowed prefixes can include up to 10 entries. The minimum length of a
prefix to enter the table is two digits and the maximum number is 4 digits.
There is no way to read the prefixes stored in the table. If you are in doubt about
a specific prefix – reenter it or delete it.
4.7.2 Feature Programming
Dial **1343**# [hear a confirmation tone] to enter to programming mode.
Dial *9194*# [hear a confirmation tone] followed by a list of prefixes, separated
by # to add entries to the table (see the following example).
Dial *9190*# [hear a confirmation tone] to Enable the Toll Restriction feature.
You can enable the feature only if there is at least one entry in the table
(otherwise you will hear a rejection tone).
Dial *9193*# [hear a confirmation tone] to Disable the Toll Restriction feature.
This does not erase the entries in the table.
Dial *9195*# [hear a confirmation tone] and then dial the prefix you want to
delete followed by a # to erase a specific entry. If the prefix was erased - you will
hear a confirmation tone. If the prefix was not found in the table – you will hear
a rejection tone. When the last prefix is erased the 111L will disable the Toll
Restriction feature.
Dial *5351*# [hear a confirmation tone] to completely erase all the Toll
Restriction entries.
Note: The prefix numbers do not include the prefix digit used to exit the PABX
environment to the public network (usually “9” or “0”).
In case of an error, an error tone is heard. Replace the handset and start the
procedure again.
Example – limit the gateway to dial to the following prefixes only: 061, 063
and 064
Dial *9194*# [hear a confirmation tone] and the list of prefixes: 061# [hear a
confirmation tone] 063# [hear a confirmation tone] 064# [hear a confirmation
tone]. Dial *9190*# [hear a confirmation tone] to Enable the feature. Go on-
hook and try the feature.
Page 17