IP Gear SmartCell 111L - 4.7 Toll Restriction

IP Gear SmartCell 111L User Guide
mobile phone and follow the menu). After the insertion of the SIM card into the
111L, clear the ‘Wrong PIN Flag’ with the DTMF command.
4.6.2 Feature Programming
Dial **1343**# [hear a confirmation tone] to enter to programming mode.
To enable the feature with the existing PIN Code of the SIM card:
Dial *6110*# [hear a confirmation tone], XXXX# [hear a confirmation tone] to
enable the PIN code request feature on the SIM. The existing PIN code of the
SIM card (XXXX) will be stored in the 111L and will be transferred to the SIM
card every time it is initiated.
To enable the feature with a PIN code different from the existing PIN Code of
the SIM card:
Dial *6100*# [hear a confirmation tone], XXXX* [hear a single tone], YYYY*
[hear a single tone], YYYY# [hear a confirmation tone] to enable the new PIN
code (YYYY) and to store it in the 111L, instead of the existing PIN code of the
SIM card (XXXX). If this operation failed, the PIN code XXXX was not the one
on the SIM card. Remove the SIM card from the unit, put it in a cellular phone
and change its code to YYYY (the value that is currently in the unit. Then cancel
the unit from lock (see later) and return the SIM card to the unit.
If you do not know the PIN code of the 111L, you have 2 options: either use a
SIM card that does not require a PIN code or perform “back to factory default”.
This will put the default value 1234 in the 111L, and continue from there.
An unsuccessful attempt to change the PIN code will result in a “Lock” of the
unit. The unit will not perform any command relevant to a PIN code change until
the Lock is cleared. To clear a lock – see later.
To disable the feature:
Dial **1343**# [hear a confirmation tone] to enter to programming mode.
Dial *6101*# [hear a confirmation tone], XXXX# [hear a confirmation tone] to
disable the PIN code request feature on the SIM. The PIN code of the SIM card
(XXXX) and the one stored in the 111L will remain unchanged.
To clear the 111L from lock:
Dial **1343**# [hear a confirmation tone] to enter to programming mode.
Dial *6122*# [hear a confirmation tone] to clear the locking of the 111L. Note
that 3 wrong attempts will put the SIM card itself into locking.
Page 16