IP Gear SmartCell 111L User Guide
4.15 DTMF Programming Summary
No Code Function Remarks
4.1 **1343**# Enter programming mode To exit programming mode – go on-hook.
4.2 *5580*# Change Rx/Tx audio gain This is followed by *70*# for TX and *71*# for Rx.
Actual changes with telephone keypad keys
4.3 *3210*# Update immediate dialling
length
The 111L will start dialling
immediately after receiving
this number of digits
This is followed by the required number of digits for
immediate dialling and then by #. Enter 0# to
deactivate immediate dialing.
4.4 *3211*# Interdigit timeout control This is followed by the number of seconds for the
timeout settings (3-9) and then by #
4.5 *8200*# Enable CLIR Enable display of GW SIM number on remote called
phone
*8201*# Disable CLIR Disable display of GW SIM number on remote called
phone
4.6 *6100*# Enable SIM PIN code
feature
This activates the SIM PIN code request on the SIM
*6101*# Disable SIM PIN code
Feature
This de-activates the SIM PIN code request on the
SIM
*6110*# Change SIM PIN code This is followed by the old PIN and twice the new
PIN
*6122*# Clear unit lock after wrong
PIN
This clears the unit’s lock after using one time a
wrong PIN of a SIM to prevent PUK situation
4.7 *5351*# Erase toll restriction table
*9190*# Activate toll restriction
feature
*9193*# De-activate toll restriction
feature
*9194*# Add toll restriction content
mode
Add # after each allowed number you want to add to
the table (white list)
*9195*# Remove entry from toll
restriction table mode
Add # after each number you want to remove from
the table
4.8 *6133*# Call duration limit Enable duration limit of calls. Insert 0 for no limit
(default value is 0)
4.9 *7610*# Set Reverse Polarity
Singling Method
4.10 *7620*# Set Pulse Drop Singling
Method
4.11 *7630*# Set Pulse Drop width Sets the width of the pulse drop. Values can be 1-99.
Default value is 20 (2 seconds)
4.12 *6150*# Erase the SMS inbox of the
SIM card
4.13 Network-lock
This feature can be changed
only by tech support
4.14 *5470*# Restore Factory Default
Make sure you have a record of the parameters,
especially the PIN code. For this action to take place,
you need to reset the unit after this command.
Page 22
To Next Page
Loading...