IP Gear SmartCell 111L User Guide
4.8 Call Duration Limit
4.8.1 Feature description
The calls (incoming and outgoing) can be limited to a certain time. This time can
vary, in steps of 1 minute - from 1 minute to 254 minutes. If the call duration
exceeds this limit, the call will be cut and the user will hear an error tone. To
continue the call, the user will have to dial again. Note: The time is accurate to
+/- 1minute.
This feature is useful in saving the cost of too-long calls and increasing the
availability of the gateway to other users.
The default value for the feature is: unlimited.
4.8.2 Feature Programming
Dial **1343**# [hear a confirmation tone] to enter to programming mode.
Dial *6133*# [hear a confirmation tone] followed by the maximum allowed
time, in minutes. Any number between 254 and 999 will be accepted as 254.
Any number over 999 will be rejected.
Example: to limit the calls to 60 minutes dial *6133*# [hear a confirmation tone]
60# [hear a confirmation tone].
Dial *6133*#0# [hear a confirmation tone] to disable this feature – the calls will
not be limited and can last forever.
4.9 Set Reverse Polarity Signaling Method
4.9.1 Feature description
If the PABX trunk connected to the unit supports Reverse Polarity signalling
method, you should use this command to set the unit to Reverse Polarity
signalling mode
.
4.9.2 Feature Programming
Dial **1343**# [hear a confirmation tone] to enter programming mode.
Dial *7610*# [hear a confirmation tone].
Page 18
To Next Page
Loading...