IP Gear SmartCell 111L - 4.15 DTMF Programming Summary

IP Gear SmartCell 111L User Guide
5 SMS Commands
5.1 General
This unit may be remotely controlled using SMS commands.
The SMS message being sent must match the structure, described in tables 5.2
and 5.3 below (both lowercase and uppercase are acceptable).
Any command will be replied with a corresponding message to its origin
number.
Once the message has been received, the unit will analyze it and carry out the
command.
5.1.1 GET command
This type of command requests current information from the unit about its
devices and functionality.
Such command will be structured from a three letter combination as described
in table 5.2 below.
5.1.2 SET command
This type of command applies programming changes to the unit as defined in
table 5.3 listed below.
Such command will be structured from a three letter combination followed
with the "=" sign and the corresponding programming feature.
Note: SMS messages are network depended and response may be delayed by
few minutes.
5.2 GET command table
Command Syntax Command Feature Applicable Response
LIS Gets the line's current state LINE IS
ONHOOK/OFFHOOK
SME Gets the IMEI number of
the SIM
SIM IMEI No.: "Usually
20 digit number"
SMS Gets the IMSI number of
the SIM
SIM IMSI No.: "Usually
15 digit number"
MME Gets the IMEI number of
the cellular Module
MODULE IMEI No.:
"Usually 15 digit number"
MSW Gets the software version
of the cellular module
Module SW Version: "As
defined by the cellular
module manufacturer"
RXL Gets the reception level in RX Level: (-51db –
Page 24