IP Gear SmartCell 111L - 4.4 Interdigit Timeout

IP Gear SmartCell 111L User Guide
When the unit is installed in a network where all the cellular phones have the
same number of digits, you can set the immediate dialing length to that number
of digits. Doing so will save you the delay after the last digit. The minimum
number of digits is 2 and the maximum is 20 digits. When you set the number of
digits to the network-standard (for example - 9) you can still dial shorter
numbers but they will be sent to the cellular network after the preset delay or
after a #.
4.3.2 Feature Programming
Dial **1343**# [hear a confirmation tone] to enter programming mode.
Dial *3210*# [hear a confirmation tone] followed by the number length,
followed by #. For example: *3210*# [hear a confirmation tone] 10# [hear a
confirmation tone] to start dialing immediately after 10 digits have been
received.
To disable this feature enter 0 as the number of digits – dial *3210*# [hear a
confirmation tone] 0# [hear a confirmation tone].
4.4 Interdigit Timeout
4.4.1 Feature description
In order to match all users dialing habits/requirements, the time out between
dialed digits may be defined by the user. The default time is 3 seconds and, if
required, the user may change it up to 9 seconds. Please note that if the
“Immediate Dialing” feature is not activated then the actual call initiation will
also be delayed by the same time. In order to overcome this, activate the
“Immediate Dialing” feature (as explained in par. 4.3) or press the “#” key after
the last dialed digit.
4.4.2 Feature Programming
Dial **1343**# [hear a confirmation tone] to enter programming mode.
Dial *3211*# [hear a confirmation tone] followed by the timeout length,
followed by #.
For example: *3211*# [hear a confirmation tone] 5# [hear a confirmation tone]
to set timeout between the digits dialed to 5 seconds.
Page 14