iPECS iPECS-MG - DKT Programming; How to Enter Programming Mode; Permanent Update Procedure; How to Reset the System

iPECS-MG Quick Start Guide
35
5.2.2 DKT Programming
5.2.2.1 How to Enter Programming Mode
To enter programming mode, perform the following Steps:
1. Lift handset or press the [MON] button on the ADMIN station; the ICM dial tone (optional) will be
presented.
2. Press the [TRANS/PGM] button and dial *#; the confirmation tone will be heard.
3. Enter the ADMIN password (if applicable); the station will be in ADMIN programming mode
(confirmation tone is heard).
4. Each program is accessed by pressing the [TRANS/PGM] button; the following will display:
5. Enter the three-digit program number; if an error is made while entering data, the [TRANS/PGM]
button will return to the previous status.
NOTE
• To return the p revious state while ADMIN programming, press the [CONF] button;
pressing the [CONF] button will clear the temporary data fields.
5.2.2.2 Permanent Update Procedure
To commit programmed data to permanent memory, perform the following Steps:
1. When data has been entered, press the [HOLD/SAVE] button to store the data permanently; if all data
was entered correctly, a confirmation tone will be heard.
2. If there were any errors in the entry, an error tone will be presented and data is not stored in the permanent
memory, and the terminal will return to the previous state.
5.2.2.3 How to Reset the System
To reset the system:
1. Press the [Trans/PGM] button.
2. Dial 499 (Reset System Code).
3. Press the FLEX2 button.
4. Press [HOLD/SAVE].
NOTE
• The system also should be reset after entering PGM100 – FLEX 1 (Nation Code Assignment).
ENTER PGM NUMBER