| Messages and troubleshooting
128
YLS-K
10 Messages and troubleshooting
10.1 Information about message displays
All laser-related warnings and errors that occur during laser operation
are displayed as active LED Indicators in the tabs Warnings (Warn-
ings tab [}96] and Errors (Alarms tab [}95]) of the software Laser-
Net.
In the event of a warning, an LED indicator in the Warnings tab lights
up. The laser remains in operation. If there is a laser-related malfunc-
tion, the LED display Laser error lights up red and the green LED indica-
tor Laser ready goes out. Any laser emission is stopped immediately.
The corresponding LED indicator for the alarm lights up in the Alarms
tab. Possible failures of an external or built-in laser chiller do not neces-
sarily lead to switching off the laser emission.
ð Detailed information about the individual messages can be found
in the tab Events .
To put the product back into operation after eliminating the problem,
the alarms must be reset. For some messages, this takes place automati-
cally; for all other messages, you must click the Reset
button in the
Control tab (Control tab [}97]).
Logging the events
All the events relating to the product are archived in
an event file and the log files in the internal memory
of the product and can be loaded with the LaserNet
application.
10.2 Status messages, warnings and alarms
Information about the status messages, warnings and alarms is col-
lected in Appendix A.
10.3 Troubleshooting
Detailed information on troubleshooting can be found in Appendix A.
To Next Page
Loading...
