29
Failed BiT 14 – Side Brush
Roomba Symptom:
o Roomba side brush does not turn or is loud
o Roomba ends with “uh-oh and 2 beeps”.
TROUBLESHOOTING
Æ Verify the side brush has been cleaned.
Æ Attach an *approved* side brush into the pcb and
retest. If test passes, then the Roomba pcb is good and
we need to inspect returned side brush.
Æ If the motor dead, replace unit. If it fails despite
cleaning, replace side brush module.
REPLACEMENT
PART
Side Brush Module
QC
o Ensure BiT passes.
To Next Page
Loading...
