ISHIDA IPC 3kg - Chapter 2 Test Mode

Manual No. 0183B 7/29 IPC Series Service Manual
Chapter 2 Test Mode
The Test Mode is used for diagnosis and/or setting at maintenance service.
2.1 Operation
2.1.1 Test Mode Flow
TARE
TARE
Setup of Scale No.
And Decimal point
Span adjustment
Setting measuring CONDITIONS
E2ROM clear
*
ON/OFF
C2 XX
C3
F x x x
END
Program No. display
Setup of Country No.
START
L003
C1 X
TARE
TARE
TARE
TARE
TARE
*
ZERO
*
+
Note: Press the memory switch at any time during test mode to record the data to the E2PROM.
Then “P-EP” appears in the display.