ITech IT6723H - Chapter2 IEEE488.2 Commands; Cls; Ese

IEEE488.2 Commands
Copyright © Itech Electronic Co., Ltd. 12
Chapter2 IEEE488.2 Commands
*CLS
This order can clean the register as follows:
⚫ Standard event status register
⚫ Quest condition register
⚫ Operation event register
⚫ Status byte register
⚫ Error code
Order syntax
*CLS
Parameter
None
*ESE
This order can set the parameter of standard event enable register. Setting
parameter can determine which bit value of standard event register is 1 and the
byte will enable ESB of status byte register is 1.
Order syntax：
*ESE <NR1>
Parameter：
0~255
Reset value：
Consult *PSC order
Example：
*ESE 128
Quest syntax：
*ESE？
Return parameter：
<NR1>
Reference order：
*ESR？ *PSC *STB？
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com