ITech IT6723H - Chapter8 List Commands; List:function; List:step; List:voltage

List Commands
Copyright © Itech Electronic Co., Ltd. 32
Chapter8 List Commands
LIST:FUNCtion
This order is used to select the state of list mode.
Order syntax：
[SOURce:]LIST:FUNCtion <0|1>
Query syntax：
[SOURce:]LIST:FUNCtion?
Return parameters：
0|1
LIST:STEP
This command is used to set the total number of steps (1~100) of the List.
Order syntax:
LIST:STEP <NR1>
Query syntax:
LIST:STEP?
Return parameters:
NR1
LIST:VOLTage
This order is used to set the steps of list file and voltage of current step.
Order syntax：
[SOURce:]LIST:VOLTage <NRf>
Parameters：
MIN~MAX
Unit：
V
Example：
LIST:VOLT 1, 3V //set the first step’s voltage to be 3V.
Query syntax：
LIST:VOLTage?
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com