IEEE488.2 Commands
Copyright © Itech Electronic Co., Ltd. 14
Quest syntax：
*OPC？
Return parameter：
<NR1>
*PSC
This order control if power supply send a query or not when it is reset.
1 OR ON: When power supply is reset, operation event enable register, query
event enable register and standard event status register are all reset.
0 OR OFF: The data of status byte register, operation event enable register,
quest event enable register and standard event status enable register is stored
in nonvolatile register, and is recalled when power supply is reset.
Order syntax：
*PSC <bool>
Parameter：
0|1|ON|OFF
Quest syntax：
*PSC？
Return parameter：
0|1
Reference order：
*ESE *SRE STAT:OPER:ENAB STAT:QUES:ENAB
*RST
This order reset the power supply to default setting.
CURR CURR:STEP CURR:TRIG CURR:PROT
DISP ON OUTP OFF TRIG:SOUR BUS VOLT 0V
VOLT:STEP VOLT:TRIG VOLT:PROT VOLT:PROT:STAT
ON
Order syntax：
*RST
Parameter：
None
*SRE <enabled value>
This order can set the parameter of standard event register. When query
status bit enable register, the power will return a decimal number, this
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
