ITech IT6723H - List:current; List:timer

List Commands
Copyright © Itech Electronic Co., Ltd. 33
Example：
LIST:VOLT? 1 //inquire the first step’s voltage.
Return parameters：
<NR2>
LIST:CURRent
This order is used to set the steps of list file and current value of current step.
Order syntax：
[SOURce:]LIST:CURRent <NRf>
Parameters：
MIN~MAX
Unit：
A
Example：
LIST:CURR 1, 2A // set the first step’s current to be 3A.
Query syntax：
LIST:CURRent?
Example：
LIST:CURR? 1 // inquire the first step’s current.
Return parameters：
<NR2>
LIST:TIMEr
This order is used to set the steps of list file and delay time of current step. This
order is used to set delay time of every steps.
Order syntax：
[SOURce:]LIST:TIMEr
Parameters：
MIN~MAX|MIN|MAX
Unit：
S
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com