ITech IT6723H - VOLT:LIMIT <Volts; Apply {<Voltage Value>|Def|Min|Max}, {<Current Value>|Def|Min|Max

Output Commands
Copyright © Itech Electronic Co., Ltd. 29
VOLT:LIMIT <volts>
This order is used to set the upper limit of the output voltage.
Order syntax：
[SOURce:]VOLTage:LIMIT[:LEVel] <NRf>
Parameters：
MIN~MAX
Unit：
V
Query syntax：
VOLTage:LIMIT?
Return parameters：
<NR2>
APPLy {<voltage value>|DEF|MIN|MAX}, {<current
value>|DEF|MIN|MAX}
This order has combined two kinds of orders: VOLTage and CURRent. When
sending this order to unit, power supply will output voltage and current
according to the current setting of this order. Of course the precondition is the
setting value is within the set range. If not, then a execution error will occur. You
can also use DEF、MIN or MAX as the setting parameters.DEF represents
factory setting. MIN will enable the voltage and current to be 0.MAX will enable
the output to be the highest value in the range.
Order syntax：
[SOURce:]APPLy <NRf>, <NRf>
Parameters：
MIN~MAX
Unit：
V, A
Query syntax：
APPLy?
Return parameters：
<NR2>, <NR2>
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com