ITech IT7300 Series - Page 34

IT7300User Manual
User Manual
34
>Recall sweep file
STEP OPERATION VFD DISPLAY
1
Press multiple keys
(Shift)+ (Sweep) to menu
operation
SWEEP
Edit Recall Disable
2
Press right arrow key then press
Enter
key to
confirm when Recall key is shining.
RECALL SWEEP
Recall Sweep=0
3 Press numeric key to select needed recall file and
press
Enter
key to confirm. VFD display “Recall
Data success! “ for 1 second.
SWEEP
Edit Recall Disable
> Set sweep test state and start test
STEP OPERATION VFD DISPLAY
1
Press multiple keys
(Shift)+ (Sweep) to menu.
SWEEP
Edit Recall Disable
2 Press right arrow key to “Disable”, press down arrow
key and
Enter
to infirm when “Disable” is shining.
the words”Sweep” appears at the right bottom,which
means the Sweep function is active.
3
Press
On/Off
key to start sweep test.
EnterEnter
key
will shining during test and will stop after that with
power off automatically.
To exit Sweep test function
STEP OPERATION VFD DISPLAY
1
Press multiple key
(Shift)+ (Sweep) to menu
operation.
SWEEP
Edit Recall Enable
2 Press right arrow key to “Enable”, press down arrow
key and
Enter
key to confirm and then exit sweep
function(Sweep words will disappeared on lower
right of VFD display )