ITech IT8600 Series Programming Guide

Load Commands
Copyright © Itech Electronic Co., Ltd. 24
load.
Command syntax:
[SOURce:]CURRent:PROTection[:LEVel] <NRf+>
Parameter:
MINimum|MAXimum|DEFault or NRf
Unit:
A
Reset value:
MAXimum
Query Syntax:
[SOURce:]CURRent:PROTection[:LEVel]? [MINimum|MAXimum]
Returned value:
<NR3>
CURRent:PEAK:PROTection
This command is used to set the load peak level of software overcurrent
protection.
Command syntax:
[SOURce:]CURRent:PEAK:PROTection[:LEVel] <NRF+>
Parameter:
MINimum|MAXimum|DEFault or NRf
Reset value:
MAXimum
Query Syntax:
[SOURce:]CURRent:PEAK:PROTection[:LEVel]? [MINimum|MAXimum]
Returned value:
<NR3>
CURRent:PROTection:DELay
This command is used to set the load delay time of software overcurrent
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8600 Series Specifications

General

Brand	ITech
Model	IT8600 Series
Category	Test Equipment
Language	English