ITech IT8600 Series

System Commands
Copyright © Itech Electronic Co., Ltd. 42
Command syntax:
SYSTem:[SETup:]CFPF:PRIOrity <CF|PF>
Parameter:
CF|PF
Query Syntax:
SYSTem:[SETup:]CFPF:PRIOrity?
Returned value:
CF|PF
SYSTem:HARMonic:FORMula
This command is used to set the harmonic formula.
Command syntax:
SYSTem[:SETup]:HARMonic:[THDistort:]FORMula <THDF|THDR>
Parameter:
THDF|THDR
Query Syntax:
SYSTem[:SETup]:HARMonic:[THDistort:]FORMula?
Returned value:
THDF| THDR
SYSTem:COMMunicate:GPIB:ADDRess
This command is used to set GPIB address of electronic load.
Command syntax:
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <NR1>
Parameter:
NR1
Parameter range:
0 to 30
Reset value:
15
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com