Load Commands
Copyright © Itech Electronic Co., Ltd. 37
WAVE:CURRent:DATA?
This command is used to obtain the current data after normalization.
Command syntax:
WAVE:CURRent:DATA[:NORMalization]?
Parameter:
<n>
Query Syntax:
WAVE:CURRent:DATA[:NORMalization]?
Returned value:
NR1，NR1…NRf，NRf
WAVE:TRIGger?
This command is used to query the trigger status.
Command syntax:
WAVE:TRIGger[:STATe]?
Returned value:
Auto| Auto?|Trig|Trig?|Stop
WAVE:SCOPe:SELection
This command is used to set waveform display options.
Command syntax:
WAVE:SCOPe:SELection
Parameter:
U|A|UA
Query syntax:
WAVE:SCOPe:SELection?
Return value:
U|A|UA
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
