ITech IT8600 Series

Load Commands
Copyright © Itech Electronic Co., Ltd. 29
Parameter:
MINimum|MAXimum|DEFault or NRf
Unit:
V
Reset value:
MAXimum
Query Syntax:
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]? [MINimum|MAXimum]
Returned value:
NR3
CFACtor
This command is used to set the CF value of electronic load.
Command syntax:
[SOURce:]CFACtor[:LEVel][:IMMediate][:AMPLitude] <NRf+>
Parameter:
MINimum|MAXimum|DEFault or NRf
Unit:
None
Reset value:
MINimum
Query Syntax:
[SOURce:]CFACtor[:LEVel][:IMMediate][:AMPLitude]? [MINimum|MAXimum]
Returned value:
<NR3>
PFACtor
This command is used to set the PF value of electronic load.
Command syntax:
[SOURce:]PFACtor[:LEVel][:IMMediate][:AMPLitude] <NRf+>
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com