ITech IT8600 Series

System Commands
Copyright © Itech Electronic Co., Ltd. 41
Chapter4 System Commands
SYSTem:MODE
This command is used to set the load mode.
Command syntax:
SYSTem:[SETup:]MODE <AC|DC>
Parameter:
AC|DC
Reset value:
AC
Query Syntax:
SYSTem:[SETup:]MODE?
Returned value:
AC|DC
SYSTem:CFPF:MODE
This command is used to set the CF/PF/BOTH mode.
Command syntax:
SYSTem:[SETup:]CFPF:MODE <CF|PF|BOTH>
Parameter:
CF|PF|BOTH
Query Syntax:
SYSTem:[SETup:]CFPF:MODE?
Returned value:
CF|PF|BOTH
SYSTem:CFPF:PRIOrity
This command is used to set the priority of CF and PF.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com