ITech IT8600 Series

Load Commands
Copyright © Itech Electronic Co., Ltd. 38
WAVE:KNOB:SELection
This command is used to set the knob options.
Command syntax:
WAVE:KNOB:SELection
Parameter:
UR|AR|UB|AB|TL|TD|T/d
Query syntax:
WAVE:KNOB:SELection?
Returned value:
UR|AR|UB|AB|TL|TD|T/d
WAVE:VOLTage:BASE
This command is used to set the voltage reference.
Command syntax:
WAVE:VOLTage:BASE
Parameter:
<NRf>
Unit:
V
Query Syntax:
WAVE:VOLTage:BASE?
Returned value:
NR3
WAVE:VOLTage:RANGe
This command is used to set the voltage range.
Command syntax
WAVE:VOLTage:RANGe
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com