ITech IT8600 Series

Load Commands
Copyright © Itech Electronic Co., Ltd. 35
Reset value:
0.0
Query Syntax:
WAVE:TRIGger:DELay:TIME?
Returned value:
<NR3>
WAVE:TRIGger:DIVTime
This command is used to set or read the time/grid value of the waveform
display.
Command syntax:
WAVE:TRIGger:DIVTime
Parameter:
0.0005|0.001|0.002|0.005|0.01|0.02|0.05|0.1|0.2
Unit:
s
Query Syntax:
WAVE:TRIGger:DIVTime?
Returned value:
<NR3>
WAVE:RUN
This command is used to start waveform capture.
Command syntax:
WAVE:RUN
Parameter:
None
Query Syntax:
None
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com