ITech IT8600 Series

Load Commands
Copyright © Itech Electronic Co., Ltd. 39
Parameter:
NR3
Query Syntax:
WAVE:VOLTage:RANGe?
Returned value
<NR3>
WAVE:CURRent:BASE
This command is used to set the current reference.
Command syntax:
WAVE:CURRent:BASE <NRf>
Parameter:
NRf
Unit:
A
Reset value:
0.0
Query Syntax:
WAVE:CURRent:BASE?
Returned value:
<NR3>
WAVE:CURRent:RANGe
This command is used to set the current range.
Command syntax:
WAVE:CURRent:RANGe
Parameter:
NR3
Unit
A
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com