ITech IT8625 - Chapter 2 Quick Start

Measurement Commands
Copyright © Itech Electronic Co., Ltd. 10
Returned value:
<NR3>
MEASure:CURRent:RMS?
FETCh:CURRent:RMS?
This command is used to read the current effective value.
Command syntax:
MEASure:[:SCALar]:CURRent:RMS?
FETCh[:SCALar]:CURRent:RMS?
Returned value:
<NR3>
MEASure:CURRent:MAXimum?
FETCh:CURRent:MAXimum?
This command is used to read the maximum current value in load input
terminal.
Command syntax:
MEASure[:SCALar]:CURRent[:AMPLitude]:MAXimum?
FETCh[:SCALar]:CURRent[:AMPLitude]:MAXimum?
Returned value:
<NR3>
MEASure:CURRent:CFACtor?
FETCh:CURRent:CFACtor?
This command is used to read the crest factor of current.
Command syntax:
MEASure[:SCALar]:CURRent:CFACtor?
FETCh[:SCALar]:CURRent:CFACtor?
Returned value:
<NR3>